a）Under the regular service condition, the front light beam shines
the position to be supposed to maintain stably
b）Front is loaded with the illuminator multipurpose vehicle to be
supposed to have the low and far beam transducer and when the
headlight high beam becomes the headlight low beam, all headlight high
beams ought to be able also to extinguish. On the identical vehicle
front illuminator does not allow left, right to be far, the low-beam
lights. alternately starts brightly;
c) When apposed setting the front illuminator far and low-beam lights,
the low-beam lights should be located on leans, in other situations
the low-beam lights should be located the flank
d）The front headlight low beam all does not allow to dazzle.
e）The shines position of the frontheadlight low beam light beam, the
front illuminator shines when is away from 10m on the screen, the first
illuminator headlight low beam light beam light and shade closure line
corner or the center point highly should be 0.6H ~0.8H (H is front
illuminator datum center highly);
f）The front headlight high beam light beam and the headlight high beam
single light beam lamp should conform to the GB 7258-20048.4.7.3rd
corresponding requirement according to the position.
6.2.15 Light signal installment request
6.2 Requirements for torque of fastener
Tight spot （N.m）Torsion value（N.m）
Column tight torque 35～45
Even fork axis nut 45～50
Front shock absorber upper nut
To Next Page
Loading...
