1 、 Inspect whether the Parking handle is loosen or
distortion,carries on the adjustment to the loosen and
distortion part.Instead the parking handle when the adjustment
can not get the request.
2、Inspect the parking Cable
Instead the breaks cable
Replace the crack and loosen protective covering of the
cable.
Pours into the few lubricating oil to increase the
flexibility of the cable.
3、Inspec the parking institution
After cleaning the parking institution,checke whether the
rectangle four-head thread in it is wear out,and instead the
it.
4.2.3.3 Reinstall the Parking system
1 、 Grease the Lithium lubricating on the rectangle
four-head thread.then load it in the parking
bracket.(AttachedFigure4-2-25)
2、Assemble the parking bracke onto the rear disk brake
clip with two pieces of inner hexagon M nuts.
3、Assemble the back-end of the parking cable onto the
parking bracke.
To Next Page
Loading...
