1.
R
everse mechanism operate parts
4.5 Inspection and maintain of reverse mechanism(refer to the
selector mechanism figure)
1、Inspect the reverse mechanism handle whether is nimbly, if
ti is not, disassemble the reverse mechanism to checke the inner
striking fork is stagnation,the steel ball is locked by
something,the spring is natural.If exist the problems all the
above, replace the parts,and try again., if still not good to
inform the special serviceman to service the reverse mechanism.
2、If the reverse mechanism appears lacks files,adjust the
connecting nut on the striking fork to have
contraposition then fasten the reverse mechanism again.
3 、 Disassemble the reverse mechanism to checke the
connecting rod of the reverse mechanism whether is
rupture,if so,instead the connecting rod.
4、Checke the intension of the pull-off spring whether is
enough.
5、Checke whether the gear is nicety,whether have jump or
To Next Page
Loading...
