Hisun HS 1000UTV - Replacing Engine Oil

Periodic Service
10-14
completely drain the oil into an oil pan.
3. After draining, reinstall the drain plug.
4. Fill with the new oil up to the upper notch on
the dipstick.
(See “LUBRICANTS, FUEL AND COOLANT” in
“MAINTENANCE” section.)
Oil capacity
Oil Filter Replaced 1.8L (1.89U.S. qts.)
Oil Filter Not Replaced 1.6L (1.68U.S. qts.)
~①② Oil level is acceptable within this range
③ Dipstick④ Oil inlet
■Replacing Engine Oil Filter
CAUTION
To avoid personal injury:
 Be sure to stop the engine before changing
the oil filter.
 Allow engine to cool down sufficiently, oil
can be hot and can cause severe burns.
1. Park the vehicle on a flat surface and raise the
cargo bed.
2. Remove the oil filter.
3. Put a film of clean engine oil on the rubber
seal of the new filter.
4. After the new filter has been replaced, the
engine oil normally reads lower on the
dipstick. Make sure that the engine oil
does not leak through the seal and check
the oil level on the dipstick after running
the engine and allowing it to cool. Then
replenish the engine oil up to the
prescribed level.
① Bolt; ② Cover
③ “O” seal ring; ④ Engine oil filter
IMPORANT:
 To prevent serious damage to the engine,
use only a genuine Hisun filter.
■Replacing Engine Oil
CAUTION
To avoid personal injury:
 Be sure to stop the engine before
changing oil.
 Allow engine to cool down sufficiently,
oil can be hot and can burn.
1. Park the vehicle on a flat surface, raise
the cargo bed, and apply the parking
brake.
2. Remove the oil filter / oil drain plug and
drain all of the old oil.
3. Put a film of clean oil onto the seal of the
new filter. Reinstall the oil filter cover.