Periodic Service
10-21
◆Replacing procedure
1) Disconnect the negative cable of the battery.
2) Open the mini-blade fuse box cover.
3) Pull out the mini-blade fuse.
4) Insert a new mini-blade fuse into the mini-
blade fuse box.
5) Close the mini-blade fuse box cover.
6) Connect the negative battery cable.
① Mini-blade fuse box cover
■Replacing Light Bulb
Head lights
Take the bulb out of the light body and
replace it with a new one.
Other lights
Detach the lens and replace the bulb
Light Capacity
Head lights 2x35W
Tail light 2x5W
Brake light 2x21W
Instrument panel light 2W
STORAGE
CAUTION
To avoid personal injury:
Do not clean the vehicle when the engine
is running.
To avoid the danger of exhaust fume
poisoning, do not operate the engine in a
closed building without proper
ventilation.
When storing, remove the key from the
key switch to avoid unauthorized
persons from operating the vehicle and
getting injured.
VEHICLE STORAGE
If you intend to store your vehicle for an
extended period of time, follow the procedures
outlined below.
These procedures will insure that the vehicle is
ready to operate with minimum preparation when
it is removed from storage.
1. Check the bolts and nuts for looseness,and
tighten if necessary.
2. Apply grease to vehicle areas where bare
metal exist and to pivot areas.
3. Unload the cargo bed.
4. Inflate the tires to a pressure a little higher
than usual.
5. Change the engine oil and run the engine to
circulate oil throughout the engine block and
internal moving parts for about 5 minutes.
With all implements lowered to the ground, coat
any exposed rods with grease(if equipped).
To Next Page
Loading...
