Figure 7-22 LPAR Packet Filtering Enabling Screen
Note:
• If you press F8: Packet Filter when the shared NIC, specified with the
cursor, is not defined in the network segment identifier, the sub-screen is
not displayed.
How to change the transmission bandwidth limitation for VF NIC
(for LPAR manager firmware version 01-9X or later)
Place the cursor at an item where an LPAR line crosses a VNIC number
column, and press F9: Set TXRATE to display the subscreen. Select a
numeric value to change, and press the Enter key.
When pressing F1 on the subscreen, you can enter a numeric value by the
100 Mbps.
Operation by LPAR manager Screen
7-55
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
