• Use same time zone in management modules, BMC, and LPAR manager.
If not, you can't know the exact time when a failure occurs, because each
time shows different.
• Set synchronizing the time by management modules to BMC and LPAR
manager.(Recommended)
The following actions are possible in the Date and Time screen.
Any values modified on this screen will not be saved automatically in the
LPAR manager System and lost at the LPAR manager boot. Press F9: Save
Configuration on the LPAR manager Menu screen explicitly to save the newly
set value. For the LPAR manager system time,
Change the system equipment time or synchronize the LPAR manager system
time by NTP server for set of LPAR manager system time.
This Date and Time screen refreshes every second, so the cursor display may
not be stable. Moreover, the time may be displayed during updating.
The following two figures show the Date and Time screen. Display of the Date
and Time screen differs, depending on whether the time setting from the NTP
server is performed.
Figure 7-33 Date and Time screen when NOT using NTP server
7-82
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
