Figure 7-49 Change of the Time zone
• Place the cursor on Setting on the Date and Time screen and press Enter
to display a sub-screen. Select "Setting" and press Enter.
Figure 7-50 Setting the NTP Config
• Place the cursor on TimeSynch on the Date and Time screen and press
Enter to display a sub-screen. Select "SVP" and press Enter.
Figure 7-51 Setting of the SVP
• Check that NTP is set to SYNC on the System Service State screen.
Figure 7-52 Checking the System Service State
• Adjust the time of LPAR using Adjust LPAR Time on the Date and Time
screen.
Operation by LPAR manager Screen
7-97
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
