Message Content
Error: Could not load loader image from Management
Module, error code:[0xXXXX].
Please check network connection with management
module and network
XXXX:EFI Status Code
Explanation Reading the LPAR manager loader failed.
What to do Check there are not any problems in a setup of a network, a LAN
switch and a connection.
If it is satisfactory after a check, Contact the reseller from which
you purchased this equipment or consult maintenance personnel.
Message Content
Error: Could not set VLAN ID[0xXXXX],Port[0xYY],error
code:[0xZZZZ].
XXXX:VLAN ID
YY:Port NO.
ZZZZ:EFI Status Code
Explanation Assignment of Tag of VLAN ID failed.
What to do Check VLAN ID is set as a value 0 to 4094.
If it is satisfactory after a check, Contact the reseller from which
you purchased this equipment or consult maintenance personnel.
Message Content
Error: Could not start loader.(XXXX)[0xYYYY]
XXXX:cause
LoadImage Error (The error of the program image deployed
on the memory)
Handle protocol Error (EFI inside error)
Start Image Error (LP-Loader Executing Error)
YYYY:EFI Status Code
Explanation Booting the LPAR manager loader failed.
What to do Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
Message Content
Error: Ipmi driver initialization failed, error code:[0xXXXX].
XXXX:EFI Status Code
Explanation An error was detected before IPMI command issue.
What to do Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
Message Content
Error: Network error occurred,retry after a few seconds.
(PortX,Cmd:[0xXXXX],detected code[0xXXXX],error
code[0xXXXX])
Explanation Because a network error occurred, communication with the
management path will be retried at communication port PortX
(MgmtX).
9-4
Messages
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
