Message Content
set variable error occured
[valname:XXXX]
[ErrorCode:8000000000000009]
Explanation LPAR manager cannot start due to shortage of NVRAM resources.
What to do Remove an unnecessary boot order from the EFI setup menu.
For details about how to remove a boot order, see the manual
Hitachi Compute Blade 500 Series EFI User's Guide.
Message Content
Stop LP initializing.(LP License is disabled.)
Please set LP license setting to enable.
Explanation The LP license is invalid.
What to do Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
Message Content
The value of MM Config Base is invalid. Change the value to
2GB.
Explanation The value of MM Config Base is invalid. Change the value to 2 GB.
What to do In the EFI setup menu, set MM Config Base to [2GB], and then
restart LPAR manager. For details about the setup method, see
the Hitachi Compute Blade 500 Series EFI User's Guide.
Message Content
The value of MM Config Base is invalid. Change the value to
3GB.
Explanation The value of MM Config Base is invalid. Change the value to 3 GB.
What to do In the EFI setup menu, set MM Config Base to [3GB], and then
restart LPAR manager. For details about the setup method, see
the Hitachi Compute Blade 500 Series EFI User's Guide.
Message Content
This LP F/W is not supported for this blade(Compute Blade
XXXXXX).
Please install another LP F/W supported for this blade.
XXXX : Server Blade Model
Explanation This LPAR manager firmware is not supported for this server
blade.
What to do Please install another LPAR manager firmware supported for this
server blade.
If any message other than described above, contact the reseller form which
you purchased the product or consult maintenance personnel.
Messages
9-9
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
