Message Content LP is not executable condition for this request. Please wait.
LPAR manager
operation
Aborts the specified process.
What to do Wait a moment and then retry the specified process.
Message Content LP is not ready for the operation
Explanation The configuration information could not be saved.
LPAR manager
operation
Aborts the specified process.
What to do Perform Force Recovery in the System Service State screen.
Message Content
LP is recovering specified LPAR from failed-migration state.
This operation prevents some operations from performing.
Explanation Not allows you to operate screens because the failed LPAR in
LPAR migration is currently being recovered.
LPAR manager
operation
The LPAR failed in LPAR migration is being recovered.
What to do None.
Message Content Inhibit ICV request for the operation
Explanation The configuration information could not be saved.
LPAR manager
operation
Aborts the specified process.
What to do Wait a while and try again.
Message Content Insufficient Processor resource
Explanation When you tried to set the number of dedicated logical processors,
a sufficient number of physical processors could not be secured.
When an LPAR is activated, the physical processors assigned to
the LPAR cannot be secured.
LPAR manager
operation
Aborts LPAR activation.
What to do Reduce the number of processors allocated or try again to
activate the LPAR after you have deactivated a currently active
LPAR.
Alternatively, check the Logical Processor Configuration screen.
Message Content Internal error (Cannot get lock).
Explanation The LPAR manager logical firmware detected an internal error.
LPAR manager
operation
Aborts the specified process.
Messages
9-15
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
