Hitachi CB 520H A1 - Page 393

Message Content Invalid second data.
LPAR manager
operation
Aborts the specified process.
What to do Correct the value and retry.
Message Content Invalid separator.
Explanation The numeric value you specified for the LPAR manager System
Date and Time change is invalid.
LPAR manager
operation
Aborts the specified process.
What to do Correct the value and retry.
Message Content Invalid year data.
Explanation The numeric value you specified for the LPAR manager System
Date and Time change is invalid.
LPAR manager
operation
Aborts the specified process.
What to do Correct the value and retry.
Message Content IP address of NTP server is needed.
Explanation NTP server setting needs IP address.
LPAR manager
operation
Stop a time-getting of NTP server
What to do Set the IP address of a NTP server to NTP Server 1 or NTP server
2.
Message Content LPAR activation failed.
Explanation The LPAR cannot be activated.
LPAR manager
operation
Aborts LPAR activation.
What to do Check that LP system logs showing failure are collected or not. If
this action takes no effect, contact the reseller from which you
purchased this equipment or consult maintenance personnel.
Message Content
LPAR activation failed(Insufficient LPAR memory(System
Used:xxMB))
Explanation LPAR run out of memory size that can be used (the allocated
memory size for the LPAR – the used memory size for the system
unit).
LPAR manager
operation
Aborts LPAR activation.
Messages
9-17
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide