Message Content
LPAR activation failed(Insufficient LPAR memory(System
Used:xxMB))
What to do Increase the allocated memory size for LPAR and then activate
the LPAR increase memory size.
Message Content
LPAR corrupted in a LPAR Migration exist,
Please try again after recovering the LPAR.
Explanation Since there is a LPAR which has failed due to LPAR migration, it
cannot be operated.
LPAR manager
operation
Aborts the specified process.
What to do Retry the specified operation to the LPAR after recovering the
LPAR Migration.
Message Content LPAR deactivation failed.
Explanation The LPAR cannot be deactivated.
LPAR manager
operation
Aborts LPAR deactivation.
What to do Check that LP system logs showing failure are collected or not. If
this action takes no effect, contact the reseller from which you
purchased this equipment or consult maintenance personnel.
Message Content LPAR start failed.
Explanation The target LPAR failed to restart.
LPAR manager
operation
Aborts the specified process.
What to do Retry the process.
Message Content Maximum number of users exceeded.
Explanation The maximum number of users has already been registered.
LPAR manager
operation
Aborts the specified process.
What to do Delete unnecessary users, and then try adding a user again.
Message Content Memory allocation failed (Fragmentation).
Explanation When you activated an LPAR, the memory capacity you specified
could not be secured.
LPAR manager
operation
Aborts LPAR activation.
9-18
Messages
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
