Message Content RTC time synchronization has failed.
What to do Check the NTP setting.
Message Content RTC time wasn't successfully synchronized last time.
Explanation Synchronizing RTC with an NTP server failed due to some
temporary factor.
What to do When RTC time synchronization cannot succeed more than a day
after this log message is collected, save the configuration and
then synchronize RTC time.
If RTC time synchronization system log is not collected even
though you have saved the configuration, consult your reseller to
call for maintenance personnel.
Message Content SVP access initialization failed.
Explanation Initializing the access to the management module failed.
What to do Contact your reseller or maintenance personnel.
Message Content The Essential model is applied to this LP.
Explanation The LPAR manager started as an Essential model, because the
temporary LP license has expired.
What to do Continue to use the LPAR manager as an Essential model or
purchase a LP license.
Message Content The temporary LP license expiration date is getting closer.
Explanation The temporary LP license will expire soon.
After the temporary license expires, the following operations will
be suppressed:
• Operation to activate LPARs
• OS startup after reactivating LPARs
• OS startup after restarting OSs
• Operations that include the operation to activate LPARs (such
as boot order configuration and boot device acquisition)
What to do Purchase an LP license, or use the LPAR manager as an Essential
model by performing the following steps:
1. Stop the LPAR manager.
2. Back up the LPAR manager configuration.
3. Update the LP license by using the management module
firmware A0270.
4. Start the LPAR manager.
For details about updating an LPAR manager license, see
Upgrading LPAR manager model in the manual Hitachi Compute
Blade 500 Series Management Module Setup Guide.
9-44
Messages
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
Need help?
General