Message Content LP updated the configuration files with XXXXXXXX.
Explanation The configuration files were automatically saved.
XXXXXXXX stands for the following configuration file name:
- InitParam.dat
- CloneInf.dat
What to do None.
Message Content LP updated the configuration files.
Explanation The configuration information with the previous version was
updated to the new version.
What to do None.
Message Content LP-LFW detected tftp error and recovered.
Explanation Although LPAR manager logical firmware detected the network
failure at the time of network boot, it was recovered.
What to do None.
Message Content I/O interrupt vector mode was changed.
Explanation I/O interrupt vector mode was changed.
What to do None.
Message Content Invalid State was recovered. (ptc.l)
Explanation LPAR manager corrected the invalid status of the ptc.l instruction.
What to do None.
Message Content Logical CPU performance returns to normal.
Explanation Recovered from performance decrease by an excess of LPAR
numbers and logical CPU numbers.
What to do None.
Message Content LPAR Migration event occurred.
Explanation LPAR migration has started or finished.
What to do None.
Message Content Physical SEL has been cleared.
Explanation Physical SEL was cleared.
What to do None.
Messages
9-55
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
