Message Content LP started in safe mode.
Note that LPAR activation is enabled in safe mode caused by
device isolation.
• Saving configuration information
• Activating the LPAR
What to do Take one of the following solutions.
• Revise the NIC and port settings specified for the
management path, and then exit safe mode.
• Back up the LPAR manager configuration and exit safe mode
and check whether physical processors, memory, PCI devices
are isolated.
Message Content LP switched a port of the NIC for SVP access.
Explanation Change the port of NIC that is for communication between LPAR
manager and management module.
What to do None.
Message Content LP switched the active port.
Explanation The active and standby paths of the LPAR manager management
NIC were switched.
What to do None.
Message Content LP System Shutdown Started.
Explanation LP System Shutdown has started.
What to do None.
Message Content
LP system time has successfully synchronized with NTP
server.
Explanation LP system time has successfully synchronized with NTP server.
What to do None
Message Content LP took a checkpoint of the source LPAR.
Explanation Performed the concurrent maintenance and LP stopped a LPAR on
the source blade.
What to do None.
Message Content LP updated configuration format.
Explanation Changed a format of the configuration information.
What to do "Save Changed Config Format" of the LP Options screen is not set
to Enabled when save a configuration information again.
9-54
Messages
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
