Hitachi CB 520H A1 - Page 443

ID Message
Operation for which an audit log is
collected
01003086
"Set the pre-boot(PB) firmware for the
LPAR. LPARxxx Value:xxx"
When the LPAR manager screen is used to
request change of the Pre-boot firmware for
an LPAR and the request succeeds
01003087
"Failed to set the pre-boot(PB)
firmware for the LPAR. LPARxxx
Value:xxx"
When the LPAR manager screen is used to
request change of the Pre-boot firmware for
an LPAR and the request fails
01003088
"Assigned the physical processor to
the logical processor for the LPAR.
LPARxxx LCPU#:xxx Value:xxx"
When HvmSh and so on is used to request
change of logical processor assignment for an
LPAR and the request immediately succeeds
0100308A
"Assigned the physical processor to
the logical processor for the LPAR.
LPARxxx LCPU#:xxx Value:xxx"
When the LPAR manager screen is used to
request change of logical processor
assignment for an LPAR and the request
succeeds
0100308B
"Failed to assign the physical
processor to the logical processor for
the LPAR. LPARxxx LCPU#:xxx Value:xxx"
When the LPAR manager screen is used to
request change of logical processor
assignment for an LPAR and the request fails
0100308C
"Set the number of logical processors
for the LPAR. LPARxxx Value:xxx"
When HvmSh and so on is used to request
change of the number of logical processors
for an LPAR and the request immediately
succeeds
0100308E
"Set the number of logical processors
for the LPAR. LPARxxx Value:xxx"
When the LPAR manager screen is used to
request change of the number of logical
processors for an LPAR and the request
succeeds
0100308F
"Failed to set the number of logical
processors for the LPAR. LPARxxx
Value:xxx"
When the LPAR manager screen is used to
request change of the number of logical
processors for an LPAR and the request fails
01003090
"Assigned the logical PCI device to
the LPAR. LPARxxx Slot#:xxx Port#:xxx
PCI#:xxx Value:xxx"
When HvmSh and so on is used to request
change of PCI device assignment for an LPAR
and the request immediately succeeds
01003092
"Assigned the logical PCI device to
the LPAR. LPARxxx Slot#:xxx Port#:xxx
PCI#:xxx Value:xxx"
When the LPAR manager screen is used to
request change of PCI device assignment for
an LPAR and the request succeeds
01003093
"Failed to assign the logical PCI
device to the LPAR. LPARxxx Slot#:xxx
Port#:xxx PCI#:xxx Value:xxx"
When the LPAR manager screen is used to
request change of PCI device assignment for
an LPAR and the request fails
01003094
"Enabled or disabled the USB Auto
Attach settings to the LPAR. LPARxxx
Slot#:xxx PCI#:xxx Value:xxx"
When HvmSh and so on is used to request
change of USB Auto Attach functionality for
an LPAR and the request immediately
succeeds
01003096
"Enabled or disabled the USB Auto
Attach settings to the LPAR. LPARxxx
Slot#:xxx PCI#:xxx Value:xxx"
When the LPAR manager screen is used to
request change of USB Auto Attach
functionality for an LPAR and the request
succeeds
Messages
9-67
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide