Hitachi CB 520H A1 - Page 457

ID Message
Operation for which an audit log is
collected
010031BA
"Requested to commit all pending
requests to the FC HBA drivers.
Accept:xxx"
When HvmSh and so on is used to request
resuming of changing the options of the FC
HBA driver of the logical EFI that has been
suspended and the request is accepted
010031BC
"Requested to cancel all pending
requests to the FC HBA drivers.
Accept:xxx"
When HvmSh and so on is used to request
cancellation of changing the options of the FC
HBA driver of the logical EFI that has been
suspended and the request is accepted
010031BE
"Set the entry of the boot order for
the LPAR. LPARxxx Entry#:xxx Type:PXE
BDF:xxx MACaddress:xxx BootName:xxx
DevPath:xxx"
When HvmSh and so on is used to request
registration of a PXE boot at the BootOrder of
the logical EFI and the request immediately
succeeds
010031C0
"Set the entry of the boot order for
the LPAR. LPARxxx Entry#:xxx Type:FC
BDF:xxx LU:xxx WWN:xxx BootName:xxx
DevPath:xxx"
When HvmSh and so on is used to request
registration of a LU boot (FC SAN boot) at the
BootOrder of the logical EFI and the request
immediately succeeds
010031C2
"Set the entry of the boot order for
the LPAR. LPARxxx Entry#:xxx
Type:iSCSI BDF:xxx LU:xxx
MACaddress:xxx BootName:xxx
DevPath:xxx"
When HvmSh and so on is used to request
registration of an iSCSI boot of the BootOrder
of the logical EFI and the request
immediately succeeds
010031C4
"Set the entry of the boot order for
the LPAR. LPARxxx Entry#:xxx Type:KVM
BDF:xxx BootName:xxx DevPath:xxx"
When HvmSh and so on is used to request
registration of a KVM-CD/DVD boot of the
BootOrder of the logical EFI and the request
immediately succeeds
010031C6
"Set the entry of the boot order for
the LPAR. LPARxxx Entry#:xxx Type:USB
BDF:xxx Port#:xxx BootName:xxx
DevPath:xxx"
When HvmSh and so on is used to request
registration of an Front-CD/DVD boot of the
BootOrder of the logical EFI and the request
immediately succeeds
010031CA
"Requested to enable or disable the
multiple queue scheduling. Accept:xxx
Value:xxx"
When HvmSh and so on is used to request
change of the forcible multiple-queue
scheduling setting and the request is
accepted
010031CE
"Requested to set the IP address
(IPv6) of CLI1. Accept:xxx Value:xxx"
When HvmSh and so on is used to request
change of LP CLI1 IPv6 address and the
request is accepted
010031D0
"Set the IP address (IPv6) of CLI1.
Value:xxx"
When the LPAR manager screen is used to
request change of LP CLI1 IPv6 address and
the request succeeds
010031D1
"Failed to set the IP address (IPv6)
of CLI1. Value:xxx"
When the LPAR manager screen is used to
request change of LP CLI1 IPv6 address and
the request fails
010031D2
"Requested to set the IP address
(IPv6) of CLI2. Accept:xxx Value:xxx"
When HvmSh and so on is used to request
change of LP CLI2 IPv6 address and the
request is accepted
Messages
9-81
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide