Hitachi CB 520H A1 - Page 458

ID Message
Operation for which an audit log is
collected
010031D4
"Set the IP address (IPv6) of CLI2.
Value:xxx"
When the LPAR manager screen is used to
request change of LP CLI2 IPv6 address and
the request succeeds
010031D5
"Failed to set the IP address (IPv6)
of CLI2. Value:xxx"
When the LPAR manager screen is used to
request change of LP CLI2 IPv6 address and
the request fails
010031D6
"Requested to set the IP address
(IPv6) of CLI3. Accept:xxx Value:xxx"
When HvmSh and so on is used to request
change of LP CLI3 IPv6 address and the
request is accepted
010031D8
"Set the IP address (IPv6) of CLI3.
Value:xxx"
When the LPAR manager screen is used to
request change of LP CLI3 IPv6 address and
the request succeeds
010031D9
"Failed to set the IP address (IPv6)
of CLI3. Value:xxx"
When the LPAR manager screen is used to
request change of LP CLI3 IPv6 address and
the request fails
010031DA
"Requested to set the IP address
(IPv6) of CLI4. Accept:xxx Value:xxx"
When HvmSh and so on is used to request
change of LP CLI4 IPv6 address and the
request is accepted
010031DC
"Set the IP address (IPv6) of CLI4.
Value:xxx"
When the LPAR manager screen is used to
request change of LP CLI4 IPv6 address and
the request succeeds
010031DD
"Failed to set the IP address (IPv6)
of CLI4. Value:xxx"
When the LPAR manager screen is used to
request change of LP CLI4 IPv6 address and
the request fails
010031DE
"Requested to set the IP address
(IPv6) of CLI5. Accept:xxx Value:xxx"
When HvmSh and so on is used to request
change of LP CLI5 IPv6 address and the
request is accepted
010031E0
"Set the IP address (IPv6) of CLI5.
Value:xxx"
When the LPAR manager screen is used to
request change of LP CLI5 IPv6 address and
the request succeeds
010031E1
"Failed to set the IP address (IPv6)
of CLI5. Value:xxx"
When the LPAR manager screen is used to
request change of LP CLI5 IPv6 address and
the request fails
010031E2
"Requested to set the IP address
(IPv6) of CLI6. Accept:xxx Value:xxx"
When HvmSh and so on is used to request
change of LP CLI6 IPv6 address and the
request is accepted
010031E4
"Set the IP address (IPv6) of CLI6.
Value:xxx"
When the LPAR manager screen is used to
request change of LP CLI6 IPv6 address and
the request succeeds
010031E5
"Failed to set the IP address (IPv6)
of CLI6. Value:xxx"
When the LPAR manager screen is used to
request change of LP CLI6 IPv6 address and
the request fails
010031E6
"Requested to set the IP address
(IPv6) of CLI7. Accept:xxx Value:xxx"
When HvmSh and so on is used to request
change of LP CLI7 IPv6 address and the
request is accepted
9-82
Messages
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide