EasyManuals Logo

Hitachi Content Platform S Series User Manual

Hitachi Content Platform S Series
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #135 background imageLoading...
Page #135 background image
2. Using the #2 Phillips screwdriver, screw the four screws into the screw
holes going from the extender side to the rail side. Tighten the screws.
Attaching the cable management arm extenders
Each cable management arm extender attaches to the rear of an outer rail
by means of a pin. The left cable management arm extender is stamped
with the letter L. The right cable management arm extender is stamped
with the letter R. The left extender attaches to the left rail. The right
extender attaches to the right rail.
To attach a cable management arm extender to an outer enclosure rail:
1. Using the #1 Phillips screwdriver, unscrew and remove the pin at the
rear of the outer rail.
2. With the flat side of the cable management arm extender facing out,
align the pin holes in the extender with the pin holes at the rear of the
outer rail.
Chapter 4: Refurbishing an HCP S30 Node
125
HCP S Series Node Refurbishment
Step 18: Unrack and pack the enclosures

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hitachi Content Platform S Series and is the answer not in the manual?

Hitachi Content Platform S Series Specifications

General IconGeneral
BrandHitachi
ModelContent Platform S Series
CategoryServer
LanguageEnglish

Related product manuals