Hitachi Content Platform S Series User Manual

3.
Conditional: Remove the outer server module rails from the rack (see
page 85)
4.
Conditional: Insert the inner server module rails into the outer rails
(see page 87)
5.
Remove the server module cover (see page 88)
6.
Remove the riser card from the server module (see page 89)
7.
Detach the four-port Ethernet PCI card from the riser card (see page
91)
8.
Detach the two-port Ethernet SFP+ PCI card from the riser card (see
page 93)
9.
Detach the SAS PCI cards from the riser card (see page 95)
10.
Reinsert the riser card into the server module (see page 98)
11.
Remove the SSDs from the server module (see page 99)
12.
Remove the airflow baffle from the server module (see page 103)
13.
Remove the memory cards from the server module (see page 103)
14.
Remove the heat sinks from the server module (see page 104)
15.
Remove the CPUs from the server module (see page 105)
16.
Reinsert the airflow baffle into the server module (see page 112)
17.
Put the cover back on the server module (see page 113)
18.
Pack the server module (see page 113)
Step 17a (conditional): Remove the server module from the rack
If the S30 Node was returned racked, you need to remove the server
module from the rack.
Chapter 4: Refurbishing an HCP S30 Node
83
HCP S Series Node Refurbishment
Step 17: Unrack, disassemble, and pack the server modules

Hitachi Content Platform S Series Specifications

General

Brand	Hitachi
Model	Content Platform S Series
Category	Server
Language	English