11.
Wipe the drives (see page 77)
12.
Shut down the S30 Node (see page 80)
13.
Disconnect the server module power cables (see page 80)
14.
Disconnect the enclosure power cables (see page 80)
15.
Uncable the enclosures (see page 81)
16.
Disconnect the server interconnect cable and, if applicable, the BMC
interconnect cables (see page 82)
17.
Unrack, disassemble, and pack the server modules (see page 82)
18.
Unrack and pack the enclosures (see page 114)
19.
Conditional: Unrack and pack the PDUs (see page 127)
What you need for refurbishing an S30 Node
For refurbishing an S30 Node, you need:
•
If the S30 Node was returned racked:
¡
A lift.
¡
A #1 Phillips screwdriver.
¡
A #2 Phillips screwdriver.
¡
A wire cutter. You need the wire cutter only if any cables are secured
to the rack.
•
A paper clip.
•
A CPUinsertion tool.
•
High-purity isopropyl alcohol and a lint-free cloth (such as a lens
cleaning cloth or coffee filter).
•
A ¼" straight screwdriver. You need this screwdriver only if the length of
the outer enclosure mounting rail needs to be adjusted.
60
Chapter 4: Refurbishing an HCP S30 Node
HCP S Series Node Refurbishment
What you need for refurbishing an S30 Node
To Next Page
Loading...
Need help?
General