4. Push down on the two release latches for the left side of the enclosure
cover. Then pull up that side to open it.
5. Remove the four empty drive placeholders from slots 29 through 32. To
remove a placeholder, with your finger hooked under the rim of the hole
in the top of the placeholder, pull the placeholder straight up out of the
slot.
6. Insert the 28 drives from the upgrade kit into slots 13 through 24, 29
through 32, and 37 through 48. To insert a drive:
a. Push back on the tab on the top of the drive.
b. The latch on the top of the drive pops open.
Caution: Do not pull the latch open past a 45-degree angle. Doing
so will damage the latch.
c. Slide the drive all the way down into the slot.
d. Close the latch, pushing down until it clicks into place.
7. If the enclosure is in a rack:
a. Position one or two people at the rear of the rack to brace the rack
while the enclosure is pushed back.
DANGER: If the rack is not braced while the enclosure is
pushed back, the rack may move, resulting in personal
injury to people in the area.
Chapter 4: Refurbishing an HCP S30 Node
67
HCP S Series Node Refurbishment
Step 2 (conditional): Insert the upgrade-kit drives into enclosures
To Next Page
Loading...
Need help?
General