Hitachi CP-WU13K - 7 Correcting Keystoning Caused by Projection Angle; 8 Turning off the Projector

17
Installation of the Projector
b. Press the MENU button on the remote control and choose Alignment  Lens Control
to activate the Lens Control OSD, press enter to go through "Zoom/Focus", "Lens Shift",
"Zoom/Focus with Grid test pattern", "Lens Shift with Grid test pattern" OSD Cyclically.
Stop at either "Zoom/Focus" or "Zoom/Focus" with Grid test pattern" OSD; then use the ()
buttons to adjust the size of the image that is projected onto the screen.
Original image size
Zoom out Zoom in
7. Correcting keystoning caused by projection angle
a. To adjust keystoning, press the MENU button on the remote control and choose
ALIGNMENT  Warp Keystone adjust and use () buttons to adjust Vertical Keystone.

b. To adjust keystoning, press the MENU button on the remote control and choose
ALIGNMENT  War p  Keystone adjust and use
) (
buttons to adjust Horizontal
Keystone.

8. Turning off the projector
Press the button on the projector or the button on the remote control at least 3 seconds to
turn off the projector. When the projector has been turned off, the cooling fan will remain in operation
for approximately 170 seconds.