24
Installation of the Projector
3D mode
There are few ways to go to the 3D mode
OSD menu: Go to Main Menu “Input > Input Selection”, and select STEREO DVI
Remote control: Press hot key “5” to go to STEREO DVI directly
Network Webpage: Go to “Source/general” > “Source” and select STEREO DVI
RS232 Commands : Use “ Input Selection” to select STEREO DVI
When this function is blanking. The 3D Mode is not available
2D mode
Please note that OSD menu is not available in 3D mode. The ways to switch back to 2D mode are:
Remote control: Press any of the input key 1-4 will switch back to 2D mode.
Network Webpage: Go to “Source/general” > “Source” and select any other source that are
available.
RS232 Commands: Use “ Input Selection” to select any other source that are available.
Turning on the projector
Refer to the instructions covered in “ Page 15 : Installation the projector. “.
Changing OSD language
By factory default, the OSD menu of the projector is displayed in English. If you wish to
switch to a different language, you can go to
MENU CONTROL Language and
choose the language you prefer for the OSD.
To Next Page
Loading...
