27
REMOTE CONTROL
Remote control
2
3
2
4
1
5
INPUT
ASPECT
RATIO
AUTO IMAGE
PAUSE TEXT
MENU
SHARPN
PHASE COLOR TINT
ADDRESSSWAPPIP
1
3
4
6
7
2
5
1. ON
This button is used to turn on the projector.
2.
OFF
This button is used to turn off the projector.
3.
1
2
3
4 5
These buttons on the remote control are the hotkeys
for different image source. By factory default, these
are:
1 = HDMI 1
2 = RGB D-15
3 = COMPONENT2
4 = COMPONENT1
5 = Stereo DVI
Note: These buttons may not work at PIP mode.
each button in the OSD Menu. To do so:
When press MENU > CONTROL > Button 1~5; use
the () buttons to choose from different sources of
input. You can choose from: HDMI 1,HDMI 2,RGB
D-15,YUV 1,RGBHV/YUV 2,SDI/HDSDI/3G and
STEREO DVI.
1
as RGB
D-15 in the OSD Menu, when you press
1
on the
remote control, the projector will display the image from
RGB D-15.
4. ()))
ENTER
the settings you have changed.
When press ENTER , You also recall LENS ADJUST
when menu is off.
5. ASPECT RATIO
You can scroll through different aspect ratios by
pressing this button repeatedly. For more information,
refer to " Page 37 : Aspect Ratio ".
6. MENU
Press this button to show or hide the OSD Menu.
7. Various image adjustment buttons
PAUSE
PAUSE
Use this button to halt projection
temporarily.
TEXT
TEXT
When TEXT is set to ON, the
user will be able to operate the
OSD Menu normally.
When TEXT is set to OFF, only
ON, OFF, 1~5, SWAP, PIP,
PAUSE will function normally;
pressing any other buttons will
not access the OSD Menu.
To Next Page
Loading...
