Hitachi CP-WU13K - Auto Image

39
OSD Menu description

H Start
Use W X
If the projected image is not at the center of the screen (i.e. shifted to right or left) and
 
following image is an example of test image from an external signal source:
Native picture Skewed left Skewed right

H Phase
Use W X
Use this function to adjust the phase of pixel sampling clock (relative to input signal).
 
phase accordingly.

V Start
Use W X
If the projected image is not at the center of the screen (i.e. shifted up or down) and ends
 
image is an example of test image from an external signal source:
Native picture
Skewed down
Skewed Up
It is recommended that when adjusting the image, the horizontal total should be adjusted before the horizontal phase. However, if

Auto Image
When Auto Image was selected in the OSD menu, press ENTER to execute the automatic image
adjustment function.
By executing this function, the projector will resync the image. Use this function when the
image source is unstable or when you notice deterioration in image quality and the projector will
automatically adjust the image size, phase and timing. (The adjustment also applies to PIP input
source).
This function is identical to the
button on the remote control. You can simply use the hot key on
the remote control to execute this function.