66
Communication settings
3. Response code / Error code
("h" shows hexadecimal)
4. ACK reply : 06h
When the projector receives the Set, Increment, Decrement or Execute , command correctly, the projector changes the
5. NAK reply : 15h
When the projector cannot understand the received command, the projector , returns the error code. In such a case, check
the sending code and send the same command again.
6. Error reply : 1Ch + 0000h
When the projector cannot execute the received command for any reasons, the projector returns the error code. In such a
case, check the sending code and the setting status of the projector
7. Data reply : 1Dh + xxxxh
When the projector receives the GET command correctly, the projector returns the response code and 2 bytes of data.
Note
suitable cables.
-Provide an interval of at least 40ms between the response code and any other code.
-Commands are not accepted during warm-up.
the computer.
To Next Page
Loading...
