54
Lamp and Filter
Maintenance
Lamp replacement
From the OSD Menu, you can go to " Page 43
: Lamp1 Run Time ". to check how long a lamp
has been used. You should also replace the lamp
when the projected image gets noticeably darker.
Contact your local dealer to purchase new
To replace the projector lamp
1. Turn off the projector and unplug the power cord.
Let the projector cool for approximately 45 minutes
before removing the lamp module for replacement.
When you turn off the projector, the lamp inside the
projector will still be very hot (approximately 200 ~
300°C). If you attempt to replace the lamp without
allowing the projector to cool, you could risk scalding
yourself. This is why you should wait for no less than
45minutes for the lamp to cool down in order to perform
the replacement safely.
2. Loosen the Projector lamp cover.
3. Remove the lamp cover.
4. Use a screw driver to loosen the screws as shown in
the illustration.
5. Grasp the metal rod on the lamp cover and pull the
lamp out.
6. Insert the new lamp in the direction shown in
the illustration into the lamp assembly; tighten
the two screws using a screw driver and make
the lamp from shaking or poor contact.
7.
screws on the lamp cover.
8. Reconnect power to the projector and reset the lamp
usage timer. Refer to " Page 43 : Lamp2 Run Time
"."Lamp2 Run Time".
To Next Page
Loading...
