8
Warning, Notices and Safety Instructions
Changing parts
Should any part of the projector be damaged, check with your servicing personnel that only
remind the servicing personnel to perform safety inspections to ensure that the projector operates
normally.
Power cord
Don't place the projector where the cord can be walked on. This may result in fraying or damage to
the power cord, especially at the plug and the point of connection between the power cord and the
projector.
the projector (refer to the descriptions printed on the power cord). If you are not sure of the power
available at the region you are in, consult your local power company to prevent damages to the
Depending on the country and region you are in, the voltage and type of socket of the wall outlet may
of your own safety.
Notices you should read prior to the installation of the projector
Safety issues related to the lamp
The lamp used in this projector contains mercury. Should the lamp be broken, please be careful when
handling the glass shards and keep the surrounding environment well ventilated. Be sure to wear a
mask that offers adequate protection before cleaning up to prevent inhaling mercury vapor that could
cause bodily harm. For instructions on lamp replacement, refer to " Page 7 : Lamp replacement ".
Take frequent breaks to let your eyes rest
Prolonged viewing of the projector screen could strain your eyes. Please be sure to rest your eyes
adequately.
Installation environment for the projector
You should avoid installing the projector at place of excessive dampness, dust or smoke. If installation
in such environment is unavoidable, be sure to have the interior of the projector
cleaned routinely to prolong the projector's lifecycle. Cleaning of the projector's interior should only be
to clean the inside of the projector by yourself.
If other light source is directly projected onto the projector screen, the color of the image from the
projector will appear to be pale and the image quality will be lower. In addition, your eyes would be
more prone to fatigue. Therefore, it is recommended that the projector be installed in places without
direct exposure to sunlight or other sources of intense light.
The ideal operating temperature range for the projector is between 0°C ~ 40°C (32°F ~ 104°F)
The ideal storage temperature range for the projector is between -20ºC ~ 60°C (-4°F ~ 140°F)
To Next Page
Loading...
Need help?
General