49
OSD Menu description
Adjust Lines
When the function is ON, there will be adjust lines on the image in order to easily adjust
the image.
The image below is an example if 2 projectors are projecting at the same image.
1. Horizontally place two projectors and have the two projected images with an overlap area and use the focus/zoom and
lens shift functions with test grid pattern to set a proper overlap area for blending with a matched grid size.
2. Color matching 2 projectors on white is done with P7 (R.G.B.C.M.Y.W) adjust in projector toolset.
3. Brightness matching 2 projectors can be done with the lamp power(Refer to adjustment by dimming the projector with
higher lumens.
4. Use Edge blend-> White level to set the blending size based on the overlap region size.
Use Edge blend-> Black level position to adjust the start position of black level compensation.
Use Edge blend-> Black level to raise the brightness of non-overlap zone such that the brightness of the overlap zone and
non-overlap zone are matched for black level.
Note1:Please note that the following allowable warp, blanking and Edge blend combination based on the underlying chip
Black Level Black Level
Black Level
Keystone Rotation Pin/Barrel 4-corner blanking
Top/Bottom or
Left/Right only
Blend along corners Black Level
Keystone X X X X X X X
Rotation X X X X X X X
Pin/Barrel X X X X X X X
4-corner X X X OK OK OK X
blanking X X X OK OK OK OK
Top/Bottom or
Left/Right only
XX XOKOK OK
Blend along corners X X X OK OK X
X X X X OK OK X
ScenergiX
ScenergiX
White Level
White Level
To Next Page
Loading...
