Default IP address settings
The following table shows the SVP default IP addresses.
The bridge setting is configured at the Distribution Center
. The user connects
to the SVP using the IP address 192.168.0.15 for LAN1/3/4 ports
(management) or 10.0.0.100 for LAN2 port (maintenance), respectively
Port Name of NIC
(user can
change a NIC
name)
Connected to Default IP
address
IP address
after bridge
is configured
Notes
LAN1 Management
(User)
Management
LAN
n/a (DHCP) 192.168.0.15/
24
Part of bridge.
IST uses
LAN1/3/4 or 2
ports for
R
emote
Desktop
Protocol
(RDP).
LAN2 Maintenance MPC or User
PC
10.0.0.100/24 <-- Not a part of
bridge. IST
uses LAN1/3/4
or 2 ports for
RDP.
LAN3 Management
(CTL1)
DKC CTL1 n/a (DHCP) 192.168.0.15/
24
Part of the
bridge.
LAN4 Management
(CTL2)
DKC CTL2 n/a (DHCP) 192.168.0.15/
24
Part of the
bridge.
IPMI n/a User PC n/a (disabled)
To enable IPMI
LAN, change
the BMC
network
configuration
on the BIOS
menu from
<-- Not supported
(up to user).
20 Overview
Hitachi Virtual Storage Platform G200, G400, G600 Service Processor Technical Reference
To Next Page
Loading...
