Hitachi G200 - Blocking Communications to Port 80

If an error message appears, see Troubleshooting Storage Navigator.
Blocking communications to port 80
The following procedure describes how to block HT
TP communications to the
SVP using port 80.
Procedure
1. Close all Device Manager - Storage Navigator sessions on the SVP.
2. Using a management console PC attached to the SVP, connect to the SVP
using Windows Remote Desktop Client.
3. On the SVP, exit to a Windows command prompt as Administrator.
4. Move to the directory where the block file exists, and then issue the
following command:
C:\MAPP\wk\Supervisor\MappIniSet\MappHttpBlock.bat
5. When the completion message appears, press an
y key to continue.
6. Exit the command prompt.
Postrequisites
To unblock port 80, repeat this procedure, but issue the following command
in step 3:
C:\MAPP\wk\Supervisor\MappIniSet\MappHttpRelease.bat
SVP support 53
Hitachi Virtual Storage Platform G200, G400, G600 Service Processor Technical Reference