Hitachi G200 - Changing the SVP IP Address; Changing the SVP IP Address in Windows 7; Changing the SVP IP Address Using the Storage Device List

Changing the SVP IP address
Y
ou can change the IP address for the SVP using the Microsoft Windows
Embedded Standard 7 operating system on the SVP or the Storage Device
List.
Changing the SVP IP address in Windows 7
Use this procedure so long as no storage system has been registered on the
SVP, or the storage system service has not been started.
Procedure
1. From a management console PC, connect to the SVP using Windows
Remote Desktop Connection.
2. On the SVP, click Start > Control PanelNetwork and Sharing Center.
3. Click Change adapter settings.
4. Click a network for which you want to set an IP address, and then set the
IP address.
Changing the SVP IP address using the Storage Device List
To use this procedure, there must be no storage system registered on the
SVP or the storage system service must not have been started.
Procedure
1. If you have not connected a management console PC to the SVP using
Windows Remote Desktop Connection, do so now.
2. On the SVP, click Start > All Programs > Hitachi Device Manager-
Storage Navigator > StorageDeviceList.
The Storage Device List window opens.
46 SVP support
Hitachi Virtual Storage Platform G200, G400, G600 Service Processor Technical Reference