What you need
To mount the HCP Anywhere edge appliance into a rack, you need:
•
#1 Phillips screwdriver
Tip: The hardware assembly is easiest with a magnetic screwdriver.
•
Velcro straps
•
Cable ties
Step 1: Prepare the rack
Remove the doors and sides from the rack.
Step 2: Install the rails
Continue the assembly by installing the server mounting rails.
To install the rails:
1. Separate the inner and outer server rails
2. Attach the inner rails to the server
3. Install the outer rails in the rack
Step 2a: Separate the inner and outer server rails
A server rail kit consists of two sets of inner and outer rails. The rails are
universal; that is, each set of rails can be used for either the left or right
side of the server.
In a new server rail kit, the inner rails are nested inside the outer rails. You
need to separate them so that you can attach the inner rails to the server
and the outer rails in the rack.
14
Chapter 2: Mounting the HCP Anywhere edge appliance into a rack
HCP Anywhere Edge Appliance On-Site Setup and Recovery
What you need
To Next Page
Loading...
Need help?
General