8. On the Specify Destination Type page, select Back up to a volume, and
then click Next.
9. On the Select Destination Volume page:
a. Click Add.
b. In the Add volumes popup, select D:\ drive, and then click OK.
c. Click Next.
10. On the Confirmation page:
a. Make sure D:\ drive appears in Backup destinations.
b. Make sure Bare metal recovery appears in Backup items.
c. Click Finish.
11. On the Summary page, click Close.
Chapter 3: Configuring the HCP Anywhere edge appliance
33
HCP Anywhere Edge Appliance On-Site Setup and Recovery
Step 7: Back up the server
To Next Page
Loading...
