●Replacing the ink 6-8
2015.07.0712:45
Com=0
Ink Drainage
Ink rep.
Ink refill
Process：Ink replacement
Confirm the ink filter is set at the right position.
Press [Start/Continue].
Operation guide
Proc. status:
Abort
Start/Continue
Circulation control [Service ]
(h) Set the ink filter.
(i) When Start/Continue is pressed, refilling of the lines with ink begins.
● After a while, ink is ejected from the nozzle. Check the position of the ink stream.
● When you want to stop the operation, press Abort .
● When abort processing was performed, select “Ink refill” from the Circulation control screen and
execute.
Display the Operation management screen and set the ink operating time to “0”.
4
Piping(D)
Ink filter
● Set the ink filter as follows.(Piping D is on the right.)
To Next Page
Loading...
