F6 – Automatic heating temperature release
This function is used to set automatic temperature release for the HEAT function.
Setting Condition setting
19 19 °C
20 20 °C
21-24 (21-24) °C
25 25 °C (factory setting)
26-28 (26-28) °C
29 29 °C
30 30 °C
F7 – Prevention of operation stoppage due to remote control operating error
F8 – Operation mode selection interlock
This function is used to prevent changes to the operating mode. The setting condition is shown below.
Setting
Condition setting
00 Not available
01 Available (factory setting)
F9 – Temperature setting interlock
This function is used to prevent changes to the temperature setting. The setting condition is shown below.
Setting
Contents
00 Not available
01 Available (factory setting)
FA – Fan speed selection interlock
This function is used to prevent changes to the fan speed. The setting condition is shown below.
Setting
Contents
00 Not available
01 Available
Fb – Automatic louver interlock
This function is used to prevent changes to automatic louver operations. The setting condition is shown below:
Setting condition
Contents
00 Not available
01 Available
FC – Lower cooling temperature setting limit
This function is useful to set the temperature range in cooling mode. It enables the cooling range to be reduced for
configuration using the remote control. The setting condition is shown below:
Setting
Contents
00 Standard
01 Lower limit +1 °C
02 Lower limit +2 °C
03-08 Lower limit +(03-08) °C
09 Lower limit +9 °C
10 Lower limit +10 °C
6 Optional functions
216
SMGB0063 rev. 1 - 10/2010
To Next Page
Loading...
Need help?
General
