Hitachi SJ700-4000HFU2

Chapter 2 Installation and Wiring
2-13
(2) Layout of main circuit terminals
The figures below show the terminal layout on the main circuit terminal block of the inverter.
Terminal layout
Inverter model
SJ700D-004-037L
FF3/FEF3/FUF3
SJ700D-007-037H
FF3/FEF3/FUF3
R0 and T0: M4
Ground terminal: M4
Other terminals: M4
Enabling PIN(J61)
Disabling PIN(J62)
EMC filter disables
(factory setting)
Dummy plug (green)
Short plug
EMC filter enables
Short plug
Dummy plug (green)
If you need to activate the
EMC filter, you need to set
the dummy plug and the
short plug in reference to
below list appropriately.
Note:
Before setting the plugs,
make sure that the power
supply is off. Otherwise, you
run the risk of electric shock.
You need to set the plugs
before power supply to the
inverter.
Dummy plug (green)
Enabling PIN(J61)
Short plug
Disabling PIN(J62)
R
(L1)
S
(L2)
T
(L3)
PD
(+1)
P
(+)
N
U
(T1)
V
(T2)
W
(T3)
R0
T0
Charge lamp
Jumper connecting terminals PD and P
When not using the DCL,
do not remove the jumper
from terminals PD and P.
G
G
RB
(-)
[Method of enabling/disabling the EMC filter function]