Hitachi SJ700-4000HFU2

Chapter 3 Operation
3-7
(3) Example of operation in basic display mode ("b037" = "04" )
- Only basic parameters can be displayed in basic display mode. (All parameters in monitor mode, four
parameters in function mode, or 20 parameters in extended function mode)
- Other parameters are not displayed. To display all parameters, select the full display mode ("b037" = "00").
<Displayable parameters and sequence of display>
Note:
If a desired parameter is not displayed, check the
setting of function "b037" (function code display
restriction). To display all parameters, specify "00"
for "b037".
No.
Display code
Item
1
d001 to d104
Monitor display
2
F001
Output frequency setting
3
F002
Acceleration (1) time setting
4
F003
Deceleration (1) time setting
5
F004
Operation direction setting
6
A001
Frequency source setting
7
A002
Run command source setting
8
A003
Base frequency setting
9
A004
Maximum frequency setting
10
A005
[AT] selection
11
A020
Multispeed frequency setting
12
A021
Multispeed 1 setting
13
A022
Multispeed 2 setting
14
A023
Multispeed 3 setting
15
A044
1st control method
16
A045
V/f gain setting
17
A085
Operation mode selection
18
b001
Selection of restart mode
19
b002
Allowable under-voltage power failure time
20
b008
Retry-after-trip selection
21
b011
Retry wait time after trip
22
b037
Function code display restriction
23
b083
Carrier frequency setting
24
b084
Initialization mode selection
25
b130
Selection of overvoltage suppression function
26
b131
Setting of overvoltage suppression level
27
C021
Setting of intelligent output terminal 11
28
C022
Setting of intelligent output terminal 12
29
C036
Alarm relay active state