Hitachi SJ700-4000HFU2

Chapter 3 Operation
3-8
Key operation and transition of the
codes on display
Key operation and transition of the monitored data on display
Monitor mode
Pressing the key with a function code displayed shows the monitored data
corresponding to the function code.
(Monitor display) (*1)
Pressing the or key with the monitored data displayed reverts to the
display of the function code corresponding to the monitored data.
* With the factory setting, the monitor shows initially after
power-on.
Pressing the key in this status changes the display to .
Function or extended function mode
Pressing the key with a function code displayed shows the data
corresponding to the function code.
(Data display)
(*1)(*2)
Data setting
Pressing the or key respectively increases or
decreases the displayed numerical data.
(Press the key until the desired data is shown.)
Pressing the key with numerical data displayed stores the
data and then returns to the display of the corresponding
function code.
Note that pressing the key with numerical data displayed
returns to the display of the function code corresponding to
the numerical data without updating the data, even if it has
been changed on display.
or
Up to the
maximum limit
Down to the
minimum limit
1
2
or
FUNC
FUNC
FUNC
STR
FUNC
STR
FUNC
FUNC
STR
FUNC
FUNC
STR
FUNC
1
2
1
2
Pressing the or key respectively scrolls up or down the code displayed in code display mode or
increases or decreases the numerical data displayed in data display mode.
Press the or key until the desired code or numerical data is shown. To scroll codes or increase/decrease
numerical data fast, press and hold the key.