Hitachi UX2 - Text Setup Rules

20
1.3.5-2 Text setup rules
(1) Line count
● When you change the line count for a print item in a certain column, you must also set the line count for the
other print items that belong to the same column.
（Example）
1
3
5
7
2
4
6
8
Transmit the line count consecutively to items 7 and 8. If you transmit the line count to only one of them,
a communication error occurs.
● When you change the line count for a print item, you must also set the line count for the other print items
that belong to the same column as the former one.
（Example）
Transmit the line count consecutively to items 7 and 8. If you transmit the line count to only one
of them, a communication error occurs.
(2) Line spacing
● When you transmit one-line setup data for a certain print item, you have to transmit a line spacing
setting of "0" as well as for the same chain as the one-line setup data. If you do not transmit a line spacing
setting of "0", a communication error occurs.
● Ensure that the same line spacing setting is selected for print items belonging to the same column.
In other words, when you transmit a new line spacing setting for a print item in a certain column,
you must consecutively transmit the same setting to the other print items in the same column.
(3) Character size and Inter-character space
● The available inter-character space varies with the character size.
See " 5.5.4 Setting Dot Matrix, Inter-character Space, and Other Parameters " (4) of the Instructions Manual.
● The total number of vertical dots cannot exceed the limit.
Machine type
Maximum number of vertical dots
UX2-D
48 dots
● Some characters cannot be entered depending on the character size. If a print item contains an unavailable
character after a character size change, its contents are changed to a space.
See " 5.5.4 Setting Dot Matrix, Inter-character Space, and Other Parameters " (3) of the Instructions Manual.
1
3
5
2
4
6
7
8
1
3
5
2
4
6
7
8
1
3
5
7
2
4
6
8
Setting items 7 and 8 to one line
Setting items 7 and 8 to two lines