Hitachi UX2 - 1.2.6. Heating of Ink

32
1.3.9 Remote Operation Transmission
1.3.9-1 Text
ESC2
Header 72H
Type
1.3.9-2 Types of control
Types of control for operation
No.
Type
Content
Function enabled status
1
Operation start
Starts to jet ink and shifts from stop status to
ready status.
(Same process as with <Startup> button)
Stop status
2
Operation stop
Stops ink jet, and shifts to stop status (Same
process as with <Shutdown> button)
When ink is being jetted
(Standby, ready status,
etc.)
3
Deflection
voltage control
(ON)
Turns deflection voltage on
(Same process as with <Ready> button in
Manual control menu window)
Standby status
4
Deflection
voltage control
(OFF)
Turns deflection voltage off
(Same process as with <Standby> button in
Manual control menu window)
Ready status
5
Fault clear
Closes the window for any fault that has
occurred.
However, the window will remain if the cause of
fault is not resolved.
When fault has
occurred
●Specify only one category of control at a time.
●Even if executing function is not possible, ACK will be answered, but no function will be executed.
Type
30H: Operation start
31H: Operation stop
32H: Deflection voltage control (ON)
33H: Deflection voltage control (OFF)
34H: Fault clear