55
1.5.2-2 Time interval (T2) between IJ printer response and printing start
(1) When Print format is set to "Individual"
Time interval (T2) between IJ printer response and printing start
The print message transfer
ACK condition is t=fixed.
The print message transfer
ACK condition is t=async.
When the character height, character
width, character orientation, ink drop
use percentage, or print format
changes before or after recall.
When the character height, character
width, character orientation, ink drop
use percentage, or print format does
not change before or after recall.
Line count/print format uniformity
●The IJ printer executes an internal process to make printing preparations in accordance with the received
print data. Do not enter the print start signal during internal process execution.
●In the overwrite-protected mode, initiate the next communication after completion of printing.
●In the overwrite-enabled mode, it is possible that next communication is sent in printing, but the fault
"Print data changeover in progress S" occurs.
●When a print start signal is input with shorter timing than T2, the fault "Print data changeover in progress M"
occurs.
●The more different items of the print format, the longer the time until ready to print.
●When the Print format is set to "Individual" and Free layout transmission is made, a communication error
will occur.
*7 If the communication time interval is not sufficiently secured, it may not operate normally.
*8 When there is a data matrix, QR code, Micro QR and GS1 DataBar, and Dotcode setting, the time is
as follows:
*9 When there is a QR code setting, T2 Minimum time is 400xN (ms)(N: Number of QR codes).
*10 When there is a QR code and GSI DataBar setting, the time is as follows:
M: Number of communication characters
N: Number of printing characters
To Next Page
Loading...
