Hitachi UX2 - Page 57

56
Time T2 when there is a data matrix, QR code, Micro QR, GS1 DataBar and Dotcode setting
When multiple barcodes are set, add T2 minimum time for each of them.
(2) When Print format is set to "Free layout"
Time interval (T2) between IJ printer response and printing start
No.
Transmission type
Conditions
T2 Minimum Time（ms)
Remarks
Within 24 items
25 items or more
1
Print description
The print message transfer
ACK condition is t=fixed.
Ｍ
１０
+ １５０
Ｍ
１０
+ １５０
*12
The print message transfer
ACK condition is t=async.
０
０
2
Print data recall
When the character height, character
width, character orientation, ink drop
use percentage, or print format
changes before or after recall.
400
400
When the character height, character
width, character orientation, ink drop
use percentage, or print format does
not change before or after recall.
400
400
*12
3
Print data registration
－
－
－
4
Print conditions
Print specifications
400
400
5
Print format
400
400
Line count/print format uniformity
－
－
6
Format setup change
200
250
7
Free layout
－
400
400
8
User pattern character
－
－
－
9
Date/time setup
－
Ｎ
１０
+ １５０
Ｎ
１０
+ １５０
*12
●The IJ printer executes an internal process to make printing preparations in accordance with the received
print data. Do not enter the print start signal during internal process execution.
●In the overwrite-protected mode, initiate the next communication after completion of printing.
●In the overwrite-enabled mode, it is possible that next communication is sent in printing, but the fault
"Print data changeover in progress S" occurs.
●When a print start signal is input with shorter timing than T2, the fault "Print data changeover in progress M"
occurs.
●The more different items of the print format, the longer the time until ready to print.
●When the Print format is set to "Free layout" and Print condition transmission of "Line count/Print format
uniformity" is made, a communication error will occur.
*7 If the communication time interval is not sufficiently secured, it may not operate normally.
*12 When there is a data matrix, QR code, Micro QR and GS1 DataBar, and Dotcode setting, the time is
as follows:
Bar code type
Character size
T2 Minimum Time
(
ms
)
Within 24 items
25 items or more
Data matrix
5×8, 10×12
8×N+20
100
12×16,18×24
15×N+40
150
QR code
QR（21×21）
200×N
200×N
QR（25×25）
300×N
300×N
QR（29×29）
400×N
400×N
QR（33×33）
500×N
500×N
Micro QR
（15×15）
100×N
100×N
GS1 data bar
15×N+50
15×N+50
Dotcode
Vert. 7/8/10 dots
300×N
300×N
Vert. 12 dots
400×N
400×N
Vert. 14 dots
600×N
600×N
Vert. 16 dots
700×N
700×N
(N: Number of
bar code)
M: Number of communication characters
N: Number of printing characters