5
(9) Free layout transmission
・An ''item number'' and ''amount of move'' are transmitted from the external device to the IJ printer.
・The IJ printer receives the ''item number'' and ''amount of move'', and then moves the item specified to
the specified position.
(10) Communication buffer
・The print contents received through print content transmission will not be reflected in printing
immediately, but will be temporarily held in buffer.
・The print contents are fetched from the buffer one by one for each printing, and reflected in
subsequent printing.
(11) Calendar conditions transmission, count conditions transmission
・Transmits and sets "initial values", "range" of count conditions, and "Substitution rules No.", "offset",
"Substitution rules", "zero suppress" of calendar condition etc. from external unit to the IJ printer.
① The USB serial converter is compatible with the driver depending on the product,
so please test it beforehand and apply it.
② For the recommended USB serial converter for the IJ printer, please contact our
sales representative.
③ Connect the USB serial converter to the USB port on the back of the IJ printer.
Do not connect to the USB port on the front of the IJ printer.
④ Do not connect multiple USB serial converters using a USB hub or the like.
⑤ Do not insert the USB serial converter during power-up of the IJ printer. Install the
USB serial converter While the power supply is disconnected.
To Next Page
Loading...
Need help?
General
