Hitachi VIV-E553LE - Page 40

4.3 Spot Noise Adjustment
ERROR!! - Spot noise compensation is inhibited by the data in the
SPOT NOISE COMPENSATION IS EEPROM.
STOPPED BY INITIAL DATA. - Turn the power on again.
PLEASE CHECK THE EEPROM. - Data in the EEPROM is defective. (Initialize it.)
PRESS ANY KEY. - Check the EEPROM, and if necessary,replace it.
ERROR! - Turn the power on again.
THRESHOLD DATA ERROR. - Data in the EEPROM is defective. (Initialize it.)
PLEASE CHECK THE EEPROM. - Check the EEPROM,and if necessary,replace it.
PRESS ANY KEY.
ERROR!!
THE SPOT NOISE IS TOO MANY.
CAN'T COMPENSATE ANY MORE.
PRESS ANY KEY.
- The amount of spot noise that can be compensated reaches the
limit.
- Turn the power on again.
- Check the CCD image sensor,and if necessary,replace it.
4.4 VCR Adjustment
ERROR: SWP_TEST>DAT FILE NOT FOUND! - The adjustment program cannot be found.
- Check the adjustment floppy disk and replace it if necessary.
- A wrong model has been selected.
- The adjustment program cannot be found.
- Check the adjustment floppy disk and replace it if necessa
THIS MODEL NEED NOT BE ADJUSTED - Awrong model has been selected.
PRESS ANY KEY - A product that needs analog adjustment is connected.
ADJUSTMENT INCOMPLETED - The value set by adjustment defective.
PRESS ANY KEY - Re-adjust.
- Check cylinder.
- Check the alignment tape.
- Check whether or not the usual operation is done correctly.
RETRY ADJUSTING. PRESS ANY KEY - Supply power again and re-adjust.
ERROR: INVALID MODEL
PRESS ANY KEY
CAMERA IS NOT READY - Check whether or not power Is supplied.
ERROR OCCURRED CAN'T PLAY BACK - No playback video.
PRESS ANY KEY - Check the playback signal.
ERROR OCCURRED NO V.SYNC FOUND - Vertical sync loss.
PRESS ANY KEY - Check the vertical sync signal.
INVALID MODEL - A wrong model has been selected.
PRESS ANY KEY - The adjustment program cannot be found.
- Check the adjustment floppy disk and replace it if necessary.
ERROR OCCURRED CAN'T RECORD - No video recording.
PRESS ANY KEY - Check the recording signal.
E3 - 20