Hitron CGNVM - Page 81

WIRELESS
Version 1.0, 02/2015. Copyright 2012 Hitron Technologies
81
Version 1.0, 02/2015. Copyright 2014 Hitron Technologies
81
Hitron CGNVM User’s Guide
Wireless Mode Select the mode of 2.4GHz wireless network that you
want to use:
802.11 11b Only: use IEEE 802.11b
802.11 11g Only: use IEEE 802.11g
802.11 11n Only: use IEEE 802.11n
802.11 B/G/N Mixed: use IEEE 802.11b, 802.11g
and 802.11n
802.11 G/N Mixed: use IEEE 802.11g and 802.11n
NOTE: Only wireless clients that support the network
protocol you select can connect to the wireless
network. If in doubt, use 11B/G/N Mixed
(default).
Wireless Channel Select the 2.4GHz wireless channel that you want to
use, or select Auto to have the CGNVM select the
optimum channel to use.
NOTE: Use the Auto setting unless you have a specific
reason to do otherwise.
WPS Enabled Use this field to turn Wifi Protected Setup (WPS) on or
off on the 2.4GHz network.
Select ON to enable WPS.
Select OFF to disable WPS.
Multiple SSID Settings
Network Name (SSID) Enter the name that you want to use for this SSID. This
is the name that identifies your network, and to which
wireless clients connect.
NOTE: It is suggested that you change the SSID from
its default, for security reasons.
Enable Use this field to enable or disable the SSID.
Select ON to enable the SSID.
Select OFF to disable the SSID.
Table 23: The Wireless: Basic Settings: 2.4G Screen (continued)