WIRELESS
Version 1.0, 02/2015. Copyright 2012 Hitron Technologies
83
Version 1.0, 02/2015. Copyright 2014 Hitron Technologies
83
Hitron CGNVM User’s Guide
Auth Mode Select the mode of authentication that you want to use.
Select WPA-PSK to use the WiFi Protected Access
(Personal) security protocol.
Select WPA2-PSK to use the WiFi Protected
Access 2 (Personal) security protocol.
Select Auto (WPA-PSK or WPA2-PSK) to use
both the WPA and the WPA2 security protocols;
clients that support WPA2 connect using this
protocol, whereas those that support only WPA
connect using this protocol.
Encrypt Mode Select the mode of encryption you want to use on the
2.4GHz network. The options that display depend on the
options you selected in the other fields in this screen.
WEP:
Select WEP64 to use a ten-digit security key.
Select WEP128 to use a twenty-six-digit security
key.
WPA-PSK, WPA2-PSK and Auto:
Select TKIP to use the Temporal Key Integrity
Protocol.
Select AES to use the Advanced Encryption
Standard.
Select TKIP/AES to allow clients using either
encryption type to connect to the CGNVM.
NOTE: Use of the TKIP encryption standard limits the
wireless network speed to 54Mbps (802.11g
speed).
Passphrase Enter the security key or password that you want to use
for the 2.4GHz wireless network. You will need to enter
this key into your wireless clients in order to allow them
to connect to the network.
Save Changes Click this to save your changes to the fields in this
screen.
Table 23: The Wireless: Basic Settings: 2.4G Screen (continued)
To Next Page
Loading...
Need help?
General
