A99UE13-1304
34
4. Notice:
4.1 Please read a label of power supply indicated on over current protector before using
this product, and ensure the supplied power can obey this product requirement.
4.2 Turn on the power after LAKC-1 over current protectors and actuators are installed.
4.3 If users select over current protector below 10A according to the product
specications, we recommend an input and output power cord within 5m with
1.25mm2 wire. If users select over current protector above 10A, we recommend
input and output power cord within 5m with 2mm2 wire to reduce over current
caused by large resistance in a power cord.
4.4 If users select the length of input and output power wire over 5m, we recommend
a larger diameter of power cord (greater than 2mm²) be selected to reduce over
current caused by large resistance.
To Next Page
Loading...
Need help?
General
